How does a boat electic system look on a diagram? - boat diagram prints
I have a 1970 V4 MAC and a V6 and I can find no similar ignition to the alternative measure minute mark. I can not understand how to remove the link to view thedrive fall. I someone can help me I would be very happy.
Boat Diagram Prints How Does A Boat Electic System Look On A Diagram?
2 comments:
http://www.rd.com/images/tfhimport/2000/ ...
Well, I do not know the exact details of the engine, but my son has a boat with an engine power of 70 common JI.
First, it is high current, low voltage. If you amperes capacity, will become a wiring problem. (The size of the wire is ideal) for long runs. So instead of sending the current total to the control console that uses relays. Thus, a small stream can be the ignition key (or other changes) a relay, the contacts in the high current circuit for the engine includes enable. So, for the seat and tilt, for example, the switch is connected to one side of the relay. When you press the switch, the relay closes and sets the engine power leveling /. It's the same concept in a used car to turn. The switch puts the power to ignition relay, which closes the circuit between the battery and starter. So it is not necessary cables from the battery the size of the wire on the dash over!
In the case of my son's boat, we had to replace all the links. In addition, it was necessary to reconstruct both TSeat and tilt motors. On this boat were links to the engine.
This should be optimistic.
Post a Comment